Learn how the Pro’s do Shed Roof Repairs

It's simpler than you think…

Man Examining his Shed roof repairShed roof repair jobs can get a bit messy. They can be hard to trace and see where the problem is and where the water is getting in.

So we did some homework and found how the professionals did it.

Needless to say they make it look easy, but the information they gave us, was very helpful.

We hope that it helps you too.

 

[hr]

Replacing Roof Shingles

Shingles are long lasting but they can break or become unstuck leaving holes for water to get into your shed. If you want to have a go at fixing it yourself here is what to do…

How to Replace a Shingle

 

[threecol_two]

It's easier than it looks!

  1. Break the seals and pull out the nails on the single you want to replace and the two above it (two rows up)
  2. If you are replacing a decent size area, you will have to break the seals and pull the nails of that area and the ones around it.
  3. If you are just replacing one, then use a knife to cut it out.
  4. Slide in your new shingle and nail it. Start at the bottom and work your way up the roof.
  5. If its cold, then use some tar to seal the shingles down. This will stop them from blowing around before they seal.

Trade tips

  1. If your flat bar has square edges, round them so they don't cut into the shingle.
  2. You can use a tar or roof patch in a tube to get an instant seal. Shingles are designed to seal in warm weather, but in cold they can use some assistance.
[/threecol_two] [threecol_one_last]
Tube

A roof sealer for sealing shingles. Available at Amazon

[/threecol_one_last] [hr]

Repairing a Metal Shed Roof

Many metal shed roofs are repaired with few tubes of silicone, but there are cleaner and more efficient ways of patching any holes.

We like the Cofair Aluminum Quick Roof Tape for its speed, durability and it is a much cleaner job. You also don't have to paint it. Once its stuck down, your done!

How to use Cofair Aluminum Quick Roof Tape

 

[threecol_two]

It's as easy as 1-2-3

  1. Clean the area
  2. Cut a piece and roll it out
  3. Then roll it to get all the bubbles out

When the tape is adhesive, and when it heats up a little it is stuck for good. [/threecol_two] [threecol_one_last]

Cofair Aluminium quick roof tape

Available at a discount from Amazon

[/threecol_one_last] [hr]

How to Re-Roof Your Shed

If you are looking to pull your shingles or other roof covering off and start again, then first start with some underlay

How to Lay Underlay on Your Shed Roof

 

[threecol_two]

A good underlay goes a long way to a waterproof shed

  1. Pull all your old roofing off and inspect your roof. You may want to replace some of your roof decking if it has been water damaged.
  2. Measure your roof, allowing for some overhang. (the guy in the video allows 75mm (3 inches)
  3. Mark lines where your overlay edges will go. Then cut your underlay to size
  4. Put the underlay on, start at the bottom of the roof and work your way to the top. The top piece should go on last.
  5. Nail it in and secure it around all edges.
  6. Now you are ready for shingles, metal roof or something else!
[/threecol_two] [threecol_one_last]
TYPAR roof underlay

This is good quality roof underlay, available cheap at Amazon

[/threecol_one_last]

Trade Tips

  1. Get yourself a sharp knife and a straightedge to make the best cuts.
  2. 3/8 inch flat head nails are appropriate for attaching underlay to your roof
  3. When applying cladding on a roof, work from the bottom up
  4. Schedule a job for a nice calm day
[hr]

Thanks for reading. Good luck with your Shed Roof Repairs.